(1) However, cutting away all the wood from the front edge of the splat to this line would have produced too sharp a chamfer .(2) He says that they've tried to provide a more three-dimensional look to the rear; he points to the chamfer on the lid of the trunk as an example.(3) The planks have to be drilled and riveted together side by side with a diagonal chamfer at their ends.(4) The lead-in chamfer in the design compensates for any misalignment during tube insertion.(5) In spite of this unusual method of use, the tool performed well in cutting a chamfer .(6) The rear screw hole had to be drilled at an angle through the top chamfer , next to the side of the throat mortise.(7) Lacking a lathe, you should be able to carefully grind a chamfer on a suitable bolt.(8) This is fairly unlikely as the tool for machining the head tube cuts the chamfer and faces the top of the head tube at the same time, leaving the correct length of cylindrical section above the chamfer .(9) These figures are based on models which Morris designed c.1864-66 for the painting of the ceiling chamfer in the Chapel of Jesus College, Cambridge.(10) The front edge of the cylinder is given a Colt blackpowder-style chamfer from the 1880s.(11) At each end of the bridge the rings are cut away to form a chamfer , to which are attached large compression yokes transferring loads to the abutments.(12) The fixed lights are recessed even further, with their surrounding frames heavily chamfered .(13) The scribed outline on the back of the splat of this chair, set about one quarter of an inch from the edge, may have been a guide for chamfering the splat after it was sawn to shape.(14) Gimson expressed his enthusiasm for craftsmanship by his use of techniques such as chamfering with a draw knife as wheelwrights did to chamfer parts of farm wagons or tools, reducing the weight of the timber without affecting strength.(15) There are unfortunate chamfers on the back corners of the plan to allow for rights of light of neighbouring buildings.(16) Processing will include turning, polishing, straightening, chamfering and precision saw cutting, SDI said.
